To put the 3M Worktunes in pairing mode, hold down the power button until the light flashes blue. Then, open the Bluetooth menu on your device and select “3M Worktunes.” The headphones will then be paired with your device.
There are a few reasons why your 3M Worktunes might not be connecting. First, make sure that the headphones are properly plugged into the audio jack on the radio. If they are plugged in correctly and the radio is still not recognizing them, try turning the radio off and then back on again. If that doesn’t work, there might be something wrong with the headphones themselves and they will need to be replaced.
To reset your Worktunes Bluetooth, hold down the power button for five seconds. You will then see a message that says “Reset.” Release the power button and wait for your device to restart.
There are a few ways to turn up the volume on 3M Worktunes. One way is to use the volume control on the device itself. Another way is to use the volume control on your phone or other device that is connected to the headphones.
There are a few ways to open a 3M Worktunes. One way is to slide the battery cover off of the top of the headset. Another way is to locate the small hole on the back of the headset and use a paper clip or something similar to pop open the battery cover.
Yes, 3M Worktunes headphones are waterproof. They have an IP rating of IPX7, which means they can be submerged in water up to 1 meter for up to 30 minutes.
The headphones are turned on by pressing and holding the power button for a few seconds.
The 3M Peltor Bluetooth can be connected in a few different ways. One way is to connect the earmuffs to the audio input of a device, such as a cell phone, laptop, or MP3 player. Another way is to connect the earmuffs to another Bluetooth device, such as a speaker or headphones.
3M Worktunes headphones take 2 hours to charge.
3M WorkTunes headphones are designed to last up to 8 hours on a single charge.
